Lanzar Car Audio Lanzar Vibe VBD500 - Manual (Page 9)

9
RADIO OPERATION
• BAND SELECTION
At tuner mode, press LOU/BND button (14) shortly to select the desired band.
The reception band will change in the following order:
• STATION SELECTION
Press MAN/SEK button (17) or MAN/SEK button (18) shortly to activate
automatic seek function. Press for several seconds until “MANUAL” appeared on
the display, the manual tuning mode is selected. If both buttons have not pressed
for several seconds, they will retune to seek tuning mode and “AUTO” appeared
on the display.
• LOCAL/DISTANCE
Press LOC button (2) to select between local and distant stations.
Local setting for reception of strong station, and a distant setting for reception of
weaker stations. This function is effect during AUTO SEEK operation.
• AUTOMATICALLY MEMORY STORING & PROGRAM SCANNING
- Automatic Memory Storing
Press AMS button (19) the radio searches from the current frequency and checks
the signal strength until one cycle search is finished. And then 6 strongest stations
are stored into the corresponding preset number button.
- Program Scanning
Press AMS button (19) shortly to scan preset station. When the field strength
level is more than the threshold level of stop level, the radio is holding at that
preset number for several seconds with releasing mute, then searches again.
• STATION STORING
Press any one of the preset buttons (15) (M1 to M6) to select a station which had
been stored in the memory. Press this button for several seconds, current station
is stored into the number button.
• MONO/STEREO
Press MON button (3) to select mono or stereo mode. You can sometimes improve
reception of distant stations by selection mono operation.
• SCAN
Press SCAN button (1) to set the function to scan mode, which scanning to higher
frequency station with receivable signal and keep on each station for several
seconds.
FM1 FM2 FM3 AM