LevelOne WPC-0100 - Manual (Page 18)

14
Configuration
•
It displays the configuration items that you can change under the AdHoc mode:
Power Saving Mode, Ethernet Conversion and Data Transmission Rate. If the mode
is Infrastructure, The Tx Rate will be fixed in “ Fully Auto “ and users can’t change
it.
Wired Equivalent Privacy
•
If you would like to enable WEP, the system will prompt a message to suggest
that you contact with your network administrator.
•
You may desire an additional measure of security in your wireless network,
which can be achieved by using the Wired Equivalent Privacy (WEP). Follow
the steps below to set your WEP:
(1) Select the data privacy algorithm you want (64 or 128 bit WEP type)
(2) Type Pass phrase
(3) Click “ Generate “ to generate automatically the corresponding WEP key.
If select 64 bit WEP type, 4 sets of WEP key will be generated; if select
128 bit WEP type, only a set WEP key will be generated.
(4) Choose one key (under 64 bit WEP type)
(5) Click “ Write “and then press “ OK “. WEP encrypts each frame
transmitted from the radio, using one of the keys entered from this panel.
(6) If you select “ Manual “, you can type the 64bit WEP key manually.
Especially note that all the blanks of WEP key have to be filled by manual
typing. Click on “ Clear “ you can clean away all the settings of
Encryption.