Lindy 32251 - Manual (Page 42)

CPU Switch Smart SUN-MAC-PCInstallation and Use Page 35
4.4 Keyboard hotkey combination
The keyboard hotkey combination is used to change a channel, set autoscan mode
or secure the product (so that the password needs to be typed before it can be used
again). The following keyboard hotkey combinations can be selected. These hotkey
combinations are used together with the command keys to trigger the required CPU
Switch Smart SUN-MAC-PC function. The left and right alt key combination is
particularly suitable for extended keyboards where additional keys can be
programmed to act as a combination of other keys. Such keyboards are supplied
with many Gateway 2000 computers. Programming spare keys to trigger the hotkey
combination allows channels to be selected via a single key stroke.
H1 - ‘CTRL’ and ‘ALT’ keys together (left or right hand keys operate) (default)
H2 - ‘CTRL’ and ‘SHIFT’ keys together (left or right hand keys operate)
H3 - ‘ALT’ and ‘SHIFT’ keys together (left or right hand keys operate)
H4 - ‘RIGHT ALT’ key
H5 - ‘LEFT ALT’ and ‘RIGHT ALT’ keys together
H6 - ‘LEFT CTRL’ and ‘LEFT ALT’ keys together
H7 - ‘RIGHT CTRL’ and ‘RIGHT ALT’ keys together
H8 - No hotkey enabled
4.5 Cycling between all channels or just the active channels
The CPU Switch Smart SUN-MAC-PC can be set to cycle between all channels or
just the active channels when using ‘Hotkeys + Tab’ or a three button mouse to
switch the channel. This avoids wasting time viewing channels that are not active.
Option are:
U7 – Cycle between all ports when switching with ‘Hotkeys + Tab’ or three button
mouse (default)
U8 – Cycle between active ports only when switching with ‘Hotkeys + Tab’ or three
button mouse
4.6 Firmware functions (version query, mouse restore and reset)
For technical support purposes, it may be necessary to find the firmware release
version for the control software in your CPU Switch Smart SUN-MAC-PC. For
example, if the release version is v1.29 the response shown to
F1 F1f f
will be a