Paralan iS550 - Manual (Page 12)

Page 12
1.14 In order for your settings to take affect, you will need to reboot the unit. Click
on the Diagnostics tab. On the Diagnostics page, click on “Reboot Device”.
The unit will begin reboot after 5 seconds. Wait until the “Status” LED on the
Bridge turns solid green.
1.15 Once the iS5xx iSCSI Bridge has rebooted and the “Status” LED is solid green
you have successfully configured your iS5xx iSCSI Bridge. If the SCSI bus
settings (see section 5.5) or the Web Port interface access (see section 5.4) is to
be changed, you will need to re-login. See steps 1.8 and 1.9 for instructions on
how to log in.
1.16 It is now time to connect all devices for your final setup. Make sure
all devices on the SCSI side of the system are powered down, i.e. iS5xx iSCSI
Bridge, SCSI drives, and SCSI hosts.
Termination
S CS I
TAPE
SCSI RAID
SCSI BUS
iS5xx iSCSI B RI DG E
iSCSI HO ST COMPUTER
10/100/1000 ET HERNET
Figure B