Phonetics Boat Remote - Manual (Page 41)

Chapter 3: Programming
41
combinations is incorporated into a phone number, it is counted as
one digit toward the total of 32 digits allowed per dial out phone
number.
Dialing to a Beeper or Pager
The following example demonstrates just one solution to program-
ming the Boat Remote for dialing to a beeper or pager. Many other
key sequences will also work. Start with steps 1–3 below; next, enter
special dialing keys where required for your beeper or pager service.
1. Press
SET
.
2. Press
PHONE NUMBER
.
3. Press any unassigned number key (from 1 to 8) to represent the
new telephone number entry.
4. Enter the complete telephone number using the number keys.
5. Press
CODE
+ 1. This instructs the unit to wait for the telephone
call to be answered by the beeper or pager service.
6. Now press
CODE
+ 2 to activate a two second pause. This
assumes the call is answered by a beeper/pager service that
immediately delivers a prerecorded voice message. The PAUSE
special code may be entered more than once to program more time
for the beeper/pager service to finish its message. Each entry of the
PAUSE special code allocates two additional seconds. The Boat
Remote will
“beep” with each entry.
7. Enter a telephone number or custom code number that will
identify the Boat Remote as the caller to your beeper or pager. A
code may consist of any number(s) you designate. Many users find it
convenient to use the telephone number to which the Boat Remote
is connected.
8. A pound may be required in some dialing situations. If required,
position the pound (#) within the telephone number where required
by pressing the pound special code,
CODE
+ 4. The unit will “beep”
each time the pound (#) special code is entered.
10. Press
ENTER
.
Example
16105581212WPP3116655#