Polycom RMX DOC2551A - Manual (Page 2)

2
If ISDN/PSTN is installed in your conferencing environment, obtain the
following information from your ISDN/PSTN Service Provider:
•
Switch Type, Line Coding and Framing, Numbering Plan and
Numbering Type
• Dial-in number range
Unpacking the RMX
1 When you receive the RMX 2000 packing case, inspect the
equipment for damage and verify that the components match the
packing slip.
2 Open the top cover of the RMX 2000 packing case and make sure
that the Installation Accessories kit contains the power cables and a
USB Key.
3 Remove the top cover, lift the RMX 2000 from the package and
place it on a flat surface.
Management Network Configuration on the
USB Key
The system is shipped with the following default IP addresses:
•
Control unit IP address – 192.168.1.254
• Shelf Management IP Address – 192.168.1.252
• Control unit subnet mask – 255.255.255.0
• Default Router IP Address – 192.168.1.1
If the RMX is connected to the public ISDN Network, an external
CSU or similar equipment is needed.
Write down the RMX’s serial number that is on a sticker on the back
of the unit. It will be needed for product registration later in the
installation process.