Quantum Data 881 - Manual (Page 360)

342 Chapter 10 Testing HDMI Sink Devices
To inject external audio into the HDMI stream:
• If you have the analyzer option you will have the VGA-to-RCA cable (part 30-00150).
Connect the AV connector to the generator’s SPDIF / AV port. Then connect the black
RCA connector to the SPDIF output of the external audio source.
• If you do not have the analyzer option, you will have the VGA-to-RCA cable (part
30-00148). Connect the AV connector to the generator’s SPDIF / AV port. Then connect
the red RCA connector to the SPDIF output of the external audio source.
To test an HDMI display using HDMI audio from an external source:
1. Set up the generator for HDMI output. See “ Setting up the generator for HDMI testing ”
on page 302.
2. Connect the external audio source to the SPDIF-A/V connector on the generator as
follows:
a. Using the RCA-to-VGA cable provided with the generator, connect the J1
connector to the SPDIF-A/V connector on the generator.
b. Connect the red RCA connector to the external audio source.
3. Press the Source key and select a format suitable for the HDMI display (for example,
DMT0660).
Alternatively, to select the format using the command line interface, enter the following
commands:
FMTP /tffs0/Library/Formats // Set format path to generator memory
FMTL DMT0660 // Loads the DMT0660 format
FMTU // Activates the DMT0660 format
4. Press the Content selection key and choose any image (for example, Master).
Alternatively, to select the image using the command line interface, enter the following
commands:
To audio player
To audio source
Red
Green
Blue
Grey
Black
To AV
connector
4O
4O
CONNECTOR
2ED
To audio source
To AV
connector
Red