TechniSat HD S2X - Manual (Page 92)

For everyday use
Switching on and off
> Switch the digital receiver on by pressing the on/standby key on either the unit itself
or on the remote control.
> Press the key again to switch the receiver off again.
> The unit is now in standby mode; the time will be shown in the display on the unit.
Programme selection
Using the programme up/down keys
> Use the up/down programme keys on the remote control or the unit itself to
move up or down by one position in the programme list.
Using the numeric keys
> Use the numeric keys to enter the desired programme number. For example
1 for programme 1
1, then 4 for programme 14
2, then 3, then 4 for programme 234
1, then 5, then 6 then 7 for programme 1567
When entering programme numbers with several digits, you have approx. three seconds
time after pressing a key to complete the entry.
If you wish to enter a number consisting of only one, two or three digits, you can speed up
the entry procedure by keeping the key depressed a little longer on the last digit.
Using the programme list
> Press the OK key.
> Now use the arrow keys up/down to mark the desired programme.
> Press the OK key and the marked programme will be selected.
> Use the arrow keys up/down to move around the list one line at a time.
> Use the left/right arrow keys to move through the list one page at a time.
Volume control
> To adjust the volume of your digital receiver, press Volume + to increase the
volume, and Volume - to decrease it.
Switching sound on/off
> Press the Sound on/off key to switch the sound on or off.
(22335600000200)
92