True Manufacturing Company TH - Manual (Page 4)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
3 3
SAFETY INFORMATION
The power cord of this appliance is equipped with a
grounding plug which mates with a standard grounding
wall outlet to minimize the possibility of electric shock
hazard from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
If the outlet is a standard 2-prong outlet, it is your
personal responsibility and obligation to have it replaced
with the properly grounded wall outlet.
The heated cabinet should always be plugged into it’s
own individual electrical circuit, which has a voltage
rating that matches the rating plate.
This provides the best performance and also prevents
overloading building wiring circuits which could cause a
fire hazard from overheated wires.
Never unplug your cabinet by pulling on the power cord.
Always grip plug firmly and pull straight out from the
outlet.
Repair or replace immediately all power cords that have
become frayed or otherwise damaged. Do not use a cord
that shows cracks or abrasion damage along its length or
at either end.
When removing the cabinet away from the wall, be
careful not to roll over or damage the power cord.
HOW TO CONNECT ELECTRICITY
Do not, under any circumstances, cut or remove the ground prong from the power cord.
For personal safety, this appliance must be properly grounded.
WARNING!
USE OF EXTENSION CORDS / ADAPTER PLUGS
Do not use adapter plugs or extension leads as these can cause safety issues and early failure of electrical components.
The use of adapters and extension cords will invalidate your warranty. NEVER USE AN EXTENSION CORD! NEVER USE AN
ADAPTER PLUG!
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - Remove lower rear grill.
Wiring diagram is positioned on the inside cabinet wall.
NEMA plugs
TRUE uses these types of
plugs. If you do not have
the right outlet have a
certified electrician install
the correct power source.
The incoming power source to the cabinet including any
adapters used must have the adequate power available
and must be properly grounded. Only adapters listed
with UL should be used.