TOA Electronics M-9000 - Manual (Page 31)

31
11.3.5. Adjustment mode setting
The screen display examples shown below may differ from actual displays.
The on-screen indications shown in red here (actually shown by flashing cursors) are parameters or setting contents to be selected with the Parameter setting knob, input channel selection key or other designated keys.
Unless otherwise specified, the indications of the [ ], [ ], [
], and [ ] arrows represent that the screen is switched with the Screen shift key.
A D J U S T E V E N T 0 1 – R O U T E O N
Event selection (p. 41) PARAMETER
Ducker attenuation level setting
Input ON/OFF and Input gain settings
D U C K E R D E P T H – 2 0
Ducker attenuation level setting (p. 42)
(For the channel on which the D-001T is used)
L O U D N E S S – O N
Loudness compensation setting (p. 41)
HPF and LPF settings (p. 42)
C O M P R E S S O R – O F F
Compressor setting (p. 42)
V O X S E N S I T I V I T Y – 3 0
VOX (Voice-Operating Switch) setting
(p. 42)
H P F – 4 0 0 H Z L P F – 1 2 5 .
Compressor setting
Output ON/OFF and Output gain settings
O U T 1 – O U T 1 O N 0 0
Output ON/OFF and Output gain settings (p. 42)
B A S S + 1 2 T R E B L E – 1 0
BASS and TREBLE settings (p. 41)
L O U D N E S S – O N
Loudness compensation setting (p. 41)
C O M P R E S S O R – O F F
Compressor setting (p. 42)
HPF and LPF settings (p. 42)
H P F – 4 0 0 H Z L P F – 1 2 5 .
Speaker parameter presetting (p. 42)
S P E Q A L L F L A T
EQ ON/OFF, Band number, Gain, Q,
and Center frequency settings
(p. 41)
E Q 1 0 + 1 2 0 7 3 1 5 .
I N 1 – I N 1 O N 0 0
Input ON/OFF and Input gain settings (p. 41)
. . : :
UTILITY MEMORY
Normal operation mode
Setting menu screen
Press for over 2 seconds.
B A S S + 1 2 T R E B L E – 1 0
BASS and TREBLE settings (p. 41)
EQ ON/OFF, Band number, Gain, Q,
and Center frequency settings
(p. 41)
E Q 1 0 + 1 2 0 7 3 1 5 .
Note
Press the Enter key to
confirm this setting.