Vector IVECO MOTOS V08 ENT M12 - Manual (Page 26)

INSTALLATION DIRECTIVE 26 V08 EnT M75 - M11 - M12 MAY 2006
9. MAIN ANALOG INSTRUMENT PANEL
Installation of the IVECO MOTORS onboard panel with
analog indicators entails connecting the panel’s JC connector
to the JB connector on engine wire harness, interposing the
appropriate extension wire harness available in 3, 5 and 7
metre-long versions. The JC-JB wire harness comprises 47
lines, each connected to the terminal identified on both con-
nectors by the same number.
To the main panel is connected the JE connector, provided
for connection to the secondary panel; in installations with-
out secondary panel, do not remove the cap of the JE con-
nector to avoid compromising the electrical continuity of the
systems’ power supply circuit.
1. Coolant temperature gauge (TA) - 2. Revolution counter and hour counter (CG) - 3.Voltmeter (V) - 4. Buzzer (SA) -
5. Indications and alarms module (MS) - 6. Engine oil pressure gauge (MO) - 7. Connector for secondary instrument panel (JE) -
8. On board panel instrument light switch (L) - 9. Engine start/stop key switch (CA) - 10. Engine stop push-button (usable only on
versions with excitation engine stop) - 11. Sound alarm inhibition push-button (P1) - 12. Connector for main panel wiring (JC) -
13. Cap with electrical continuity connection.
HOURS
oF
electronic
RPMx100
oC
V
bar
04_233_n
1
12
2
3 4 5
6
7
11 10 9 8
13
Figure 2