VXI 3002 - Manual (Page 55)

3-25
Sweep control
To make these commands operational they must first be enabled by the CFRQ:MODE SWEPT
command. These commands enable you to start the sweep in the selected increments from the
chosen reference frequency, pause the sweep, step the sweep up or down from the paused position,
and continue the sweep. At any time when the sweep is stopped you can either return to the
reference frequency or transfer the current frequency as the new reference frequency.
SWEEP [not used alone]
:GO Commence Sweep
:HALT Pause Sweep
:CONT Continue Sweep
:RESET Reset sweep to Start Value
:RETN Return to original setting
:XFER Transfer current value as the new setting
:UP Go UP one sweep step while paused
:DN Go DOWN one sweep step while paused
Data type : None
Allowed suffices : None
Default suffix : None
Examples: SWEEP:GO
SWEEP:RESET