Vidikron 140/150 - Manual (Page 52)

Installation
40 Vision Model 140/150 Owner’s Operating Manual
PRE
L
IMINAR
Y
3.11
Installing and Adjusting
the CineWide Anamorphic
Lens If you are installing a CineWide-equipped projector, proceed as follows to install and adjust
the anamorphic lens. Note that some components shipped with your projector may differ
slightly from what is shown in these instructions.
Attach Lens Mounting
Assembly to Lens Motor
Carriage Plate (CineWide
with AutoScope) or Base
Plate (fixed CineWide)
1. Remove the two Z-Adjustment Levers and 1/4-20 Fiber Washers from the bottom of the
lens mounting assembly.
2. Place the Lens Mounting Assembly on top of (or under, if the projector is inverted) the
Lens Motor Carriage Plate or Base Plate, so that the two threaded posts at the bottom of
the Z-Adjustment Plate pass through the corresponding slots on the carriage plate or
base plate.
3. Secure the Lens Mounting Assembly to the plate with the Z-Adjustment Levers and
Washers that you removed in Step 1.
It is extremely important that the primary lens is properly adjusted
before you install the anamorphic lens. Ensure that the 16:9 or 4:3
image from the primary lens is perfectly centered on the screen.
Note
➤