Asus Crosshair II Formula - Manual (Page 104)

4-32 Chapter 4: BIOS setup
ROG Logo [Enabled]
If this item is set to �Enabled��, the box labeled as Republic of Gamers on the
heatpipe assembly lights up when the system is on.
Configuration options: [�nabled] [Disabled]
Voltiminder LED [ON]
Allows you to turn on/off the onboard Voltiminder LED.
Configuration options: [ON] [OFF]
LCD Poster Off [Enabled]
Allows you to enable or disable the LCD Poster.
Configuration options: [Disabled] [�nabled]
If you want to create a RAID 0, 1, 0+1, 5 or JBOD configuration from the Serial ATA
hard disk drives, set this item to �RAID��.
If you want to use the Serial ATA hard disk drives as Parallel ATA physical storage
devices, keep the default setting �IDE��.
If you want the Serial ATA hard disk drives to use the Advanced Host Controller
Interface (AHCI), set this item to �AHCI��.
Use SATA 1–4 connectors for IDE mode. SATA 5–6 connectors support AHCI
mode and RAID mode only. Make sure to install the AHCI driver or RAID driver
in the bundled support DVD before connecting devices to SATA 5–6 connectors.
Otherwise, the devices will not work.
4.5.7 LCD Poster and Onboard LED Control
Select Menu
Item Specific Help
Set ROG Logo Enabled/
Disabled
Phoenix-AwardBIOS CMOS Setup Utility
Advanced
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →←: Select Menu Enter: Select SubMenu F10: Save and Exit
LCD Poster and Onboard LED Control
ROG Logo [Enabled]
Voltiminder LED [ON]
SB LED Selection [SB Voltage]
LCD Poster Off [Enabled]
LCD Poster Backlight [Disabled]
LCD Poster Mode [Current Time]
x LCD Poster String