Specifications and features – Lectrosonics SMV User Manual

Page 23

Advertising
background image

Super-Minature Belt Pack Transmitter

Rio Rancho, NM

23

The FCC requires that the following statement be in-

cluded in this manual for the RM:

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device

must accept any interference received, including interference

that may cause undesired operation.

This device complies with Industry Canada radiation exposure
limits as set forth for a controlled “professional” use only.

Block 24 614.400 - 639.900

Block 25 640.000 - 665.500

Block 26 665.600 - 691.100

Operating frequencies:

Block 470 470.100 - 495.600

Block 19 486.400 - 511.900

Block 20 512.000 - 537.500

Block 21 537.600 - 563.100

Block 22 563.200 - 588.700

Block 23 588.800 - 607.900

614.100 - 614.300

Specifications and Features

The FCC requires that the following statements be

included in this manual for the SMV and SMQV:

For body worn operation, this transmitter models has

been tested and meets the FCC RF exposure guidelines

when used with the Lectrosonics accessories supplied or

designated for this product. Use of other accessories may

not ensure compliance with FCC RF exposure guidelines.

Contact Lectrosonics if you have any questions or need more

information about RF exposure using this product..

This device complies with FCC radiation exposure limits as

set forth for an uncontrolled environment. This device should

be installed and operated so that its antenna(s) are not co-

located or operating in conjunction with any other antenna or
transmitter.

(Frequency usage varies by country)

Frequency range:

256 frequencies in 100 kHz steps

for one 25.5 MHz wide block

Channel Spacing:

100 kHz

Frequency selection:

Control panel mounted membrane switches

RF Power output:

Switchable; 50, 100 or 250 mW

Compatibility Modes (6)

Digital Hybrid Wireless

®

(400 Series),

200 Series, 100 Series, Mode 3 , Mode 6, IFB

Pilot tone:

25 to 32 kHz; 5 kHz deviation

(in 400 Series Mode)

Frequency stability:

± 0.002%

Deviation:

± 75 kHz max. (in 400 Series Mode)

Spurious radiation:

60 dB below carrier

Equivalent input noise:

–125 dBV, A-weighted

Input level:

If set for dynamic mic:

0.5 mV to 50 mV before limiting.

Greater than 1 V with limiting.

If set for electret lavaliere mic:

1.7 uA to 170 uA before limiting.

Greater than 5000 uA (5 mA) with limiting.

Line level input:

17 mV to 1.7 V before limiting.

Greater than 50 V with limiting.

Input impedance:

Dynamic mic:

300 Ohms

Electret lavaliere:

Input is virtual ground with servo adjusted

constant current bias

Line level:

2.7 k Ohms

Input limiter:

DSP Controlled Soft limiter, 30 dB range

Bias voltages:

Fixed 5 V at up to 5 mA

Selectable 2 V or 4 V servo bias for any

electret lavaliere.

Gain control range:

44 dB; panel mounted membrane switches

Modulation indicators:

Dual bicolor LEDs indicate modulation of

–20, -10, 0, +10 dB referenced to

full modulation.

Controls:

Control panel with LCD and four membrane

switches.

Low frequency roll-off:

Adjustable from 35 to 150 Hz.

30

100

1kHz

10k

20k

+6

+3

0dB

-3

-6

-9

-12

Line in

Mic in 150 Hz

Roll-off

Mic in 35 Hz

Roll-off

Audio Frequency Response:

35 Hz to 20 kHz, +/-1 dB (The low frequency

roll-off is adjustable - see graph above)

Signal to Noise Ratio (dB):

(overall system, 400 Series mode)

(Note: the dual envelope “soft”

limiter provides exceptionally

good handling of transients

using variable attack and release

time constants. The gradual onset of limiting in the design begins below full

modulation, which reduces the measured figure for SNR without limiting by 4.5 dB)

SmartNR

No Limiting

w/Limiting

OFF 103.5 108.0
NORMAL 107.0

111.5

FULL 108.5 113.0

Total Harmonic Distortion:

0.2% typical (400 Series mode)

Audio Input Jack:

Switchcraft 5-pin locking (TA5F)

Antenna: Flexible, unbreakable steel cable.
Batteries:

1.5 Volt AA lithium

Lithium

Battery Life:

SMV 50 mW (1 AA):

7.25 hrs

SMV 100 mW (1 AA):

5.5 hrs

SMV 250 mW (1 AA):

3 hrs

SMQV 50 mW (2 AA):

14.5 hrs

SMQV 100 mW (2 AA):

14 hrs

SMQV 250 mW (2 AA):

7.5 hrs

Weight:

RM: 2.3 oz.. (65.8 grams) with lithium battery

SMQV: 3.7 oz.. (105 grams) with lithium batteries

Overall Dimensions:
RM:

2.3 x 1.8 x 0.64 inches

(not including microphone/lanyard)

58 x 46 x 16 mm

(not including microphone/lanyard)

RM2: 2.125 x 1.25 x 1.125 inches

(not including microphone/lanyard)

54 x 32 x 29 mm

(not including microphone/lanyard)

SMV: 2.3 x 1.8 x 0.64 inches

(not including microphone/lanyard)

58 x 46 x 16 mm

(not including microphone/lanyard)

SMQV: 2.3 x 2.4 x 0.64 inches

(not including microphone)

58 x 60 x 16 mm

(not including microphone)

Emission Designator: 180KF3E
Specifications subject to change without notice.

Advertising