Lectrosonics SMV - Manual (Page 7)

Super-Minature Belt Pack Transmitter
Rio Rancho, NM 7
We recommend using lithium batteries for longest life.
Refer to the battery life listings in the specifications.
Batteries are inserted (+) end first on both single and
double battery models.
To install new batteries:
1. Turn the Battery Cover Plate Thumbscrew coun-
terclockwise a few turns until the door will rotate. If
you continue to rotate the thumbscrew, the door will
separate from the transmitter.
2. Insert the new batteries into the housing. The posi-
tive (+) battery terminal goes into the transmitter
first.
3. Align the Battery Cover Plate and tighten the Bat-
tery Cover Plate Thumbscrew. Apply pressure to the
cover plate to press the batteries into the housing
while rotating the thumbscrew to tighten the cover
plate flush to the housing.
Battery Installation
Two battery
compartments
(SMQV)
Kevlar
covered vent
Polarity
engraved into
housing
Attaching and Removing
the Microphone
The flexible sleeve over the 5-pin plug on the micro-
phone helps prevent dust and moisture from getting into
the input jack. The flange around the rim of the connec-
tor on the transmitter helps retain the sleeve after it is
installed and
The following procedure simplifies the attachment and
removal of the microphone to assure the sleeve is
seated securely.
Align the pins on the plug and jack and insert the con-
nector.
1
If the sleeve is pulled down
and covering the connector,
squeeze the end of the sleeve
so you can feel the connector
inside and press it into the jack
until it latches.
Pinch and
squeeze the
sleeve on this end
to work it down
over the flange.
2
Pinch and squeeze the sleeve
near the flange and work it
down with a kneading motion
over the flange all the way
around until it stays in place
flush with the housing. Pull on
the connector to make sure it
is firmly latched.
3
Release button
To remove the connector, pull
the sleeve back to expose the
black release button. Press
the button to unlatch the plug.