IDEC DATAVS2 Series - Manual (Page 70)

SVS2 Series Instruction Manual
65
11. INSPECTIONS AND PERIODIC MAINTENANCE
Correct system maintenance consists in removing dust or foreign objects from sensor and keeping the
configuration software updated to the latest release.
Remove any dust build-up from sensor body using a soft cloth; if needed, dampen cloth slightly with a
mild detergent solution.
To clean off dust and fingerprints from the lenses, use an anti-static compressed air can. Use a cloth
and a specific lens detergent to remove any residue.
Avoid using:
• alcohol-based detergents or solvents;
• wool or synthetic cloth.
Visit the web site of Datasensor S.p.A. (www.datasensor.com) to check for software updates.
To check version and date of the software installed on your system, see Help About.
11.1. Warranty
The product you purchased is warranted to be free from manufacturing defects for a period of 36
(thirty-six) months from date of manufacture.
Warranty does not cover damage and defects resulting from improper use of the sensor or accidental
damage due to shock or in the event the product is dropped.
The sensor contains cutting-edge electronic components that cannot be repaired or replaced by the
final user. Do not dismantle the device or make any changes to its components or the warranty will
become null and void.
Datasensor S.p.a. may not be held liable for damage to persons or property resulting from failure to
comply with the provisions reported herein.
In the event of problems, contact the after sales /repair service of DATASENSOR S.p.A.
After Sales Service
Tel.:
+39 051 6765611
Fax: +39 051 6759324
e-mail: [email protected]