LevelOne WAP-6101 - Manual (Page 15)

WPA-6101 300Mbps Wireless Ceiling Gigabit PoE Access Point
Configure Slave AP via WEC Button
Step 1
Check WiFi LED of Access Point which acts as Master Mode.
(Press Reset/WEC button 5~10 sec then release Button to change Mode .When System
is ready Status LED in Solid : It is in Master Mode)
Step 2
Check WiFi LED of Access Point which acts as Slave Mode.
(Press Reset/WEC button 5~10 sec then release Button to change Mode .When System
is ready Status LED in Flash : It is in Slave Mode)
Step 3
Click WEC Button (about 1second) of master AP and any slave AP as one pair
simultaneously
Step 4
WiFi LED of Master and Slave AP will flash and Negotiate WiFi Profile Configuration. This
Process will finish within 20~30 sec.
Then Check WiFi LED:
LED in Slow flash: Wireless Connection doesn't establish.
LED in Solid : Wireless Connection established successfully.
※If Negotiation failed or Master or Slave AP don
’t existed, WiFi LED will Flash 2 min.
Please try again.
※WEC Application bases on WiFi WPS Technology and only supports to use
“AES” encryption to negotiate, currently. Please notify before configuring AP in
Master Mode.