Wds only mode – LevelOne WAP-6101 User Manual
Page 24
WPA-6101
when there is no wireless traffics.
3. Wireless Schedule: The wireless radio can be turn off according to the schedule
rule you specified. By default, the wireless radio is always turned on when the
wireless module is enabled.
4. Network ID (SSID): Network ID is used for identifying the Wireless LAN (WLAN).
Client stations can roam freely over this device and other Access Points that
have the same Network ID. (The factory default setting is “default”)
5. SSID Broadcast: The device will broadcast beacons that have some information,
including SSID so that wireless clients can know how many AP devices by
scanning the network. Therefore, if this setting is configured as “Disable”, the
wireless clients can not find the device from beacons.
6. VLAN ID: Supports mapping of SSIDs to VLANs to separate workgroups across
wireless and wired domains.
7. Max Supported Stations: Support Max Stations to associated related SSID.
8. Channel: The radio channel number. The permissible channels depend on the
Regulatory Domain. The factory default setting is auto channel selection.
9. Wireless Mode: RF1 Module can c
hoose “N only”, “G/N mixed” or “B/G/N
mixed” and the factory default setting is “B/G/N mixed”.
10. Authentication & Encryption: You may select one of the following
authentications to secure your wireless network: Open, Shared, Auto, WPA-PSK,
WPA, WPA2-PSK, WPA2, WPA-PSK/WPA2-PSK,WPA /WPA2, or 802.1x.
11. Remote AP MAC 1 ~ Remote AP MAC 4: If you do not enable the Lazy mode,
you have to enter the wireless MAC address for each WDS peer one by one.
Afterwards,
click on “Save” to store your settings or click “Undo” to give up the
changes.
3.1.3.1.3
WDS Only Mode
WDS (Wireless Distributed System) function let this access point acts as a wireless
LAN access point and repeater at the same time. Users can use this feature to build
up a large wireless network
in a large space like airports, hotels and schools …etc.