LevelOne WAP-6101 - Manual (Page 33)

WPA-6101 300Mbps Wireless Ceiling Gigabit PoE Access Point
5. SNMPv3 Settings: User 1/2: This device supports up to two SNMP
management accounts. You can specify the account permission as “Read” or
“Read/Write” respectively.
6. User 1/2 AUTH Mode: Select MD5 or SHA as the method of password
encryption for the specified level of access, or to disable authentication.
7. User 1/2 Privacy Mode: You can configure the SNMP privacy mode. There are
three modes for you to choose: “noAuthNoPriv” for both authentication and
private key are not required, “authNoPriv” for no private key required, and
“authPriv” for both authentication and private key required.
8. Username 1/2: Use this field to identify the user name for the specified level of
access.
9. Password 1/2: Use this field to set the password for the specified level of
access.
10. User 1/2 Priv Key: Use this field to define the encryption key for the specified
level of access.
11. Trap Event Receiver 1 ~ 4: Enter the IP addresses or Domain Name of your
SNMP Management PCs. You have to specify the IP address, so that the device
can send SNMP Trap message to the management PCs consequently.
3.3 System
In this section you can see system information, system logs, use system tools for system
update and do service scheduling and system administration setting.