LevelOne WHG-1000 - Manual (Page 100)

WHG-1000 300Mbps Wireless PoE Hotspot Gateway
User's Manual
100
 Notification E-mail Setup :
 Receiver E-mail Address (es) : Up to 3 E-mail address can be set up to receive the notification. These are
the receiver's E-mail address.
 Sending Interval : The time interval (in minute) to send the E-mail report. (Default is 1440 minutes; the
range is between 10 to 4200 minutes)
 Billing Report Time : The start time of sending e-mail. For example : the Billing Report Time is 14:00 and
Sending Interval is 6 hours, the system will send report on 20:00.
 SMTP Sending Test : Click Send button to verify Notification E-mail settings. Below depicts an example
for success sending test.
 Syslog Setup : There are 3 types of Syslog supported : Syslog Log, On-Demand User Log and Session Log.
Enter the specify IP address and Port number to sent report.
The all history log are saved in the DRAM, if you restart system, the all of history log will empty.
Change these settings as described here and click Save button to save your changes. Click Reboot button to
activate your changes.
If the history E-mail has been entered above Notification settings, after Sending Interval, the system will send
History E-mail to receiver's E-mail address automatically.
 Traffic Log :
As shown in the following figure, each line is traffic history record consisting of 10 fields : Date, Auth Type, Status,
Passcode/Username, IP, MAC, Packets In, Bytes In, Packets Out and Bytes Out.