Vitrex 103500 - Manual (Page 3)

02 03
Contents
Safety Instructions ...................................................3
Machine Specification & Electrical Requirements ......4
Assembly & Operating Instructions ...................... 5-7
Maintenance & Warranty .........................................8
900W Bridge Saw
Safety Instructions
To use this tool correctly, you must
observe the Safety Regulations, the
Assembly Instructions and the Operation
Instructions contained in this Manual.
All persons who use and service the
machine must be acquainted with this
Manual and must be informed about any
potential hazards.
Children and infirm people must not use
this tool. Children must be supervised at
all times if they are in the area in which
the tool is being used.
It is also imperative that you observe the
accident prevention regulations in force in
your area. The same applies for general
rules of occupational health and safety.
• Take suitable precautions to protect
your eyes, ears, lungs and hands
when operating the Wet Saw.
• Keep children and others away from
the machine whilst in use.
• Only use circular blades with
a continuous rim– DO NOT USE
segmented circular blades, saw blades
or abrasive disks.
• The machine should be used indoors
only, in a clean, dry,well lit area and
on a clutter free, flat work surface.
• Avoid wearing loose clothing, ties,
rings, bracelets or other loose items
which may become caught in the
moving parts. Long hair should also
be tied back or contained.
• Always ensure that all loose tools and
components are removed from the
immediate working area.
• Switch machine off between cuts and
disconnect from mains supply before
carrying out any maintenance,
cleaning or changing the blade.
• When using an extension lead, check that
it is capable of carrying the current required
- failure to do so may result in loss of power
and overheating.
• Do not leave the saw running
unattended or touch the blade whilst
in motion – always use the blade guard
when cutting.
• Replace damaged blades immediately
and ensure that new blades are fitted
correctly to run in the direction
indicated on the blade.
• Only recommended replacement parts
should be used with this machine – use of
improper accessories could cause serious
injury
Automatic Overload
Protection
To prevent overheating this machine has
automatic overload protection which is
designed to cut power to the motor.
Should the automatic overload protection
trip, ensure that mains power supply and
machine switch are turned off.
After ten seconds press the breaker
button next to the main switch and restart
the machine.
Tel: +44 (0) 1253 789180 Tel: +44 (0) 1253 789180