Vitrex 103500 - Manual (Page 7)

06 07
Remove the cover retaining screws and take off
the blade guard.
The bridge saw comes with handles for ease of
moving the machine.
Whilst holding the shaft with the spanner wrench,
turn the blade retaining nut clockwise to release
using the hex wrench.
Ensure that the new blade is correctly seated
against the shaft and that the directional arrow
matches that on the blade guard. Replace the
flange and nut, taking care not to overtighten.
Rotate blade to ensure correct alignment.
Replace the blade guard and water tubes.
For transportation the saw between jobs, wheels
can be mounted at the top of the folded legs, just
below the angled stabilising bracket. The saw
can now be moved by lifting the handle at the
opposite end of the machine.
Note: Please clean the pump immediately after you stop
use. Otherwise the filter foam and the impeller could
be stuck by the dry debris. So you must replace the filter
foam or the pump.
1. Clean the pump
To clean the pump, remove the intake Cover, and
then take out of the filter foam and impeller cover.
Use a small brush or stream of water to remove any
debris on the foam and the impeller.
2. Replace the filter foam
To replace the filter foam, remove the intake cover,
then take out of the filter foam and put into a
new one.
Two replacement filter pads supplied with machine.
Moving the Bridge Saw
Transportation
Pump Maintenance
Tel: +44 (0) 1253 789180 Tel: +44 (0) 1253 789180
900W Bridge Saw