HP Surestore 6.140 Tape Library - Manual (Page 103)

Library Administration
Running Library Diagnostic Tests
Chapter 3 3-29
Li
b
ra
ry Ad
mi
ni
s
trat
ion
Running Library Diagnostic Tests
Use the following procedure to run internal tests of library functions.
Table 3-8 on page 3-29 describes these tests.
1. From Administration, select [More] to display additional administrative
options. Select the Run Test menu.
2. From Run Test , use the [-] or [+] key to view available tests.
3. Select [OK] to select the test.
4. Select the number of times this test will run.
5. Select [Run] to start the test cycle. The test results will display at the
conclusion of the test cycle.
NOTE Select [Stop] to abort a test. The current test cycle completes before the
test stops. Stopping the test may take a few minutes.
Main Menu ->
Administration ->
Run Test
Table 3-8 Front Panel Diagnostic Tests
Test Description
Check Inventory Physically scans the entire library to determine
which slots and drives contain tapes and reads
all bar code labels.
Recalibrate Library Performs the power-up self-tests. Each test runs
one time per test loop. This test recalibrates the
mechanics and clears hard errors, but not the
hard error log.