Configuring the library for fibre channel, Configuring the library for fibre channel -15, Configuration -15 – HP Surestore 6.140 Tape Library User Manual
Page 89
Library Administration
Configuring the Library for Fibre Channel
Chapter 3
3-15
Li
b
ra
ry Ad
mi
ni
s
trat
ion
Configuring the Library for Fibre Channel
NOTE
Refer to Appendix C if you are unfamiliar with Fibre Channel terminology
before beginning this procedure.
The optional Fibre Channel interface(s) serves as a bridge between SCSI
and Fibre Channel.
NOTE
It is not necessary to connect the library to its Fibre Channel topology (e.g.
arbitrated loop or fabric) before configuration.
Configuration
NOTE
When Fibre Channel interfaces are installed in the library, device SCSI
IDs cannot be changed from their factory default.
Though you do not need to set SCSI IDs for Fibre Channel, you will need
to configure Fibre Channel addressing.
1. Enter the
Fibre Channel
menu.
2. Select the level where the Fibre Channel interface you want to
configure is located.
Use the
[-]
key to select a lower level in the library.
Use the
[+]
key to select a higher level in the library.
Select
[OK]
if the level is correct.
Main Menu
->
Administration
->
Change Configuration
->
Fibre Channel