HP OpenView Storage Management Appliance and Software - Manual (Page 77)

Monitoring the SAN
61 Storage Management Appliance Software User Guide
Information for each event appears in the following columns for each log.
Event Log Information Audit Log Information
Type Type
Date Date
Time
Time
Source User
Device Device
Acknowledged (Yes - No)
Category
Event Code Acknowledged (Yes - No)
Event Code
Hold the cursor over an event code to display a short pop-up description as shown
in
Figure 37 .
The system automatically assigns an unacknowledged status when first recording
an event in either log. As a user assigned the Administrator privilege level, you
can change the status of any event to Acknowledged = Yes to indicate the event
cause has been examined and no further action is required. The Storage
Management Appliance displays system status information in the Session pane
and the Status page based on unacknowledged entries in the Event and Audit
logs.
Both the Event Log and Audit Log pages have the following Tasks buttons:
■ Event or Audit Details—Displays a Log Details page with complete
information about an entry selected on the Event or Audit Log page.
■ Download Log—Displays a Download Audit Log or Download Event Log
page.
■ Log Properties—Displays the Event Log Properties or Audit Log
Properties page. Both pages let you specify the size and contents of the logs.
The maximum size you can set for the Event Log is 16 MB; the maximum
Audit Log is 8 MB.
■ Clear Log—Deletes all entries from the active log after you respond
positively to a request for confirmation. To save existing log entries for future
reference you must download the current log.
■ Acknowledge—Changes the status of selected log entries to acknowledged
after you respond positively to a request for confirmation.
■ Acknowledge All—Changes the status of all log entries to acknowledged
after you respond positively to a request for confirmation.