Aussie 8462 - Manual (Page 20)

20
It is not necessary to remove and wash the ceramic bri-
quettes in order to keep them clean. Burning off the residue
after each cooking should be sufficient. Heavily impregnated
ceramic briquettes should be turned over so that the dirty
side faces the burners in order to burn off any residue.
· Always turn the LP gas cylinder valve “Off” when
not in use. Allow grill to cool before handling parts
or cleaning.
· Empty the foil pan and grease tray after each
cooking session so excessive grease does not
accumulate.
Failure to remove grease may result in grease
dripping onto the cart and/or a grease fire in the tray.
· Never light the LP gas grill without the foil pan and
· Before each use, check your Bottom Panel, Grease Tray,
and Foil Pan. If there is excessive grease buildup, clean
and replace.
· Make sure Bottom Panel, Grease Tray, & Foil Pan are in
place before each grilling session.
· Failure to remove grease from the Foil Pan may result in
grease dripping onto the cart and/or a grease fire in the
tray.
· The Foil Pan can be cleaned or replaced with a standard
size foil pan (apprx. 5-1/2” W. x 8-1/2” L. x 1-1/8” H.)
found at your local grocer.
· Always turn off the LP gas cylinder at the LP
cylinder valve when not in use. Allow grill to cool
before handling or cleaning parts.
How to Clean the Grill Body
1) Remove cooking surfaces and burners before full
cleaning.
2) Remove excess grease and/or fat from the grill body
with a soft plastic or wooden scraper. Never use steel
wool or other abrasive cleaning product on porcelain
coated surfaces. It is not necessary to remove all the
grease from the body.
3) For further cleaning, use hot soapy water and a cloth, or
nylon-bristled brush only. Do not immerse the gas
controls or manifold in water.
4) When finished cleaning, replace burners and cooking
surfaces according to Steps 8 & 10 in the
Assembly Instructions.
5) Check burner operation after reassembly.
· Always turn off the LP gas cylinder at the LP
cylinder valve when not in use. Allow grill to cool
before handling parts or cleaning.
· Do not use aerosols or store flammable liquids or
materials near this gas grill.
In addition to the above Care and Maintenance Instruction,
periodically check and tighten all nuts, bolts, and screws.
· Never store an LP gas cylinder indoors (empty or
filled). If storing the gas grill indoors, disconnect
the LP gas cylinder and store it outdoors out of the
reach of children.
· Never leave an LP gas cylinder inside a vehicle
which may become overheated by the sun.
· Never store a spare or disconnected LP gas
cylinder under or near the LP gas grill.
· Always turn off the gas cylinder when not in use.
Allow grill to cool before handling parts or
cleaning.
· Even though your LP gas cylinder may appear to be
empty, gas may still be present and the cylinder
should be transported and stored accordingly.
· Store your LP gas grill in a cool dry place .
· Disconnect LP gas cylinder from grill and store outside, in
a dry, well-ventilated area, away from any sources of heat
or ignition. Re-cap LP cylinder valve with the Safety Cap.
· Remove burners and wrap with aluminum foil to prevent
insects from entering the burner holes. Store wrapped
burners on top of the cooking grids.
· Before next use, remove aluminum foil and reinstall
burners, ceramic briquette trays, and grids according to
steps 8 & 10 of Assembly Instructions.
· Check your LP gas grill for gas leaks, deterioration, proper
assembly, and burner obstructions before using the grill
after periods of storage and/or non-use(i.e. over winter).
Ceramic Briquettes
Bottom Panel/ Grease Tray
Cleaning the Grill Body
Preventive Maintenance
Storage