Aussie 8462 - Manual (Page 27)

TROUBLESHOOTING
Problem
Flames blow out
Flare up
Persistent grease fire
Unable to fill LP tank
Humming or
whistling from the
regulator
Possible Cause
High or gusting winds
Gas in LP cylinder is low
Excess flow valve tripped
Grease build up
Excessive fat in meat
Grease trapped around burner
system
Some dealers have older fill
nozzles with worn threads.
Outside temperature, humidity,
barometric pressure, and the
gas level within the tank may
cause the rubber diaphragm
inside the regulator to vibrate,
making a humming or
whistling sound.
Solution
Turn front of grill to face wind or increase flame height.
Check LP gas cylinder. Refill if necessary.
See “Low flame” problem above.
Clean grill.
Trim fat from meat before grilling.
Turn control knobs “off” and turn handle of LP cylinder clock-
wise until it stops. Open hood carefully and let fire burn out.
After the grill cools, remove and clean all parts.
The worn nozzles don’t have enough “bite” to engage the valve.
Try another licensed LP dealer.
Although this sound may be alarming, this is NOT dangerous as
long as it is not accompanied by the smell of gas. Simply adjust
the burner settings and usually the sound will subside. If the
hummng sound persists, a change in atmosperic conditions will
eventually stop the vibration.
If your problem is not resolved from the information provided above, please call Customer Service at
1-800-251-7558.
27
Cabinet Doors Do Not
Close Cabinet is not aligned. Loosen cabinet bolts & shift cabinet by applying pressure to
one side until doors are aligned, then retighten the bolts.