Vogels PFT 8810 - Manual (Page 4)

www.vogels.com 9532-010-Z01-00
1
3
2
4
8 7
9 10
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
PFT8810
4mm 4mm
4x 4x
4x 4x
With the rear of the lower pan exposed now would be the
time to place and wire any powered support products feed-
ing the display with the power and signal cable being fed
between the front and rear upper cover panels. Power and
signal cable can also be run up through the three rubber
grommet hole in the base on the pan as well.
Once housed the rear cover panel may now be installed with
the four M6 x 10mm “button head” Allen screws supplied.
Access to the inner pan is still available through the rear
oval access cover. Install the lower front panel cover to the frame front and
secure to the frame assembly with the four each M6 x 1.0 x
10mm “button head” Allen head screws supplied
5mm
Install the two header frame to the mainframe aligning the
the lowest hole in the main frame with the 46” or 55” hole
depending on the screen size you will be using on your
video wall. Secure the lower cross bar in the appropriate
marked hole with the four each M8 x 60mm button head Al-
len screw and flat washer supplied. Confirm the cross bar is
horizontal level and tighten securely to the main frame