Vollrath Mix30 - Manual (Page 12)

English
Mixer
12
ADJUSTMENT Pushbuttons [K2] - [K3]
These pushbuttons are enabled only after pressing SET UP [K8]. They increase or decrease set values. For more details
on their use, see Par. 6.4 “Setting Up”.
MANUAL BEATING Pushbutton [K4]
When pressing the pushbutton, its indicator [Z4] goes on and the beater starts operating CONTINUOUSLY. When pressing
the pushbutton again, the beater stops and the indicator goes out.
HIGH HEATING TO 85 °C (185 °F) Pushbutton [K5]
When pressing, a full automatic High Temperature heating and cooling mixing cycle commences. On completion, the
machine enters the Preservation mode. For more details see Par. 6.3. “Heating and cooling cycles”.
The indicator [Z5] remains on for the entire duration of the cycle.
LOW HEATING TO 65 °C (149 °F) Pushbutton [K6]
When pressing, a full automatic Low Temperature heating and cooling mixing cycle commences. On completion, the ma-
chine enters the Preservation mode. For more details see Par. 6.3 “Heating and cooling cycles”.
The indicator [Z6] remains on for the entire duration of the cycle.
MANUAL REFRIGERATION/PRESERVATION Pushbutton [K7]
When the pushbutton’s indicator [Z7] is on, the machine is in preservation mode: the mixture inside the tub is maintained at
a temperature of approximately 4°C (39 °F) (or the final preset temperature). The beater, starting at the same time as the
refrigerator, shifts the mixture to maintain it homogenous and to maintain the temperature uniform.
Press the pushbutton to manually turn on (indicator on) or off (indicator off) the Preservation mode, to stop heating stage
during heating and cooling mixing cycle.
SET UP Pushbutton [K8]
When pressing, the display shows the heating and cooling mixing cycle’s main settings. Should the need arise to modify
them, press ADJUSTMENT [K2] and [K3]. For more details see Par. 6.4 “Setting Up”.
WASH Pushbutton [K9]
When pressing, the automatic washing of the tap commences. See also Par. 6.7 “Washing the tap”.
Digital Display
When turning on and during regular functioning, the display always shows the temperature inside the tub (together with that
of the mixture inside);
- During setting up, the display shows current settings;
- If it shows “ ooo ” (three small squares), the lid is either open or incorrectly closed.