6 partial tap washing – Vollrath Mix30 User Manual
Page 15
English
Operating instructions
15
-
start required for heating and cooling mixing cycle by pressing HIGH [K5] or LOW [K6] temperature cycle;
RESIDUAL HAZARD: DURING HEATING, THE PRODUCT BECOMES VERY
HOT (+65 / 149 °F...+85°C / 185 °F ). SERIOUS HEALTH DAMAGE CAN BE
CAUSED BY CONTACT WITH THE LID [5], THE TAP [11] AND THE DEVICE'S
SURFACE [35] TOO. WHEN LID IS OPENED THE MACHINE STOPS,
HOWEVER, THE MIXTURE REMAINS VERY HOT.
IS THEREFORE RECOMMENDED THAT YOU ALWAYS CHECK THAT
HEATING AND COOLING MIXING CYCLE IS COMPLETED OR, IN ANY
CASE, THAT DISPLAY SHOWS A SUFFICIENTLY LOW TEMPERATURE
BEFORE OPENING LID OR TAP.
-
wait until production is completed. This is indicated when HIGH or LOW TEMPERATURE CYCLE indicators [Z5] or [Z6]
go out and PRESERVATION’s indicator [Z7] is on. The display will show the Preservation temperature.
Note:
On completion of the cycle, the machine maintains mixture at the preset temperature, provided that lid is correctly
closed and PRESERVATION’s indicator [Z7] is on.
In case ingredients need adding to the mixture:
-
press correct pushbutton to stop cycle in progress and open the lid;
-
add ingredients and close the lid;
-
press the same pushbutton to start cycle.
When the mixture is ready to be dispensed:
-
turn drip tray [26] sideways and place suitable container beneath the tap;
-
open the tap turning the handle to the left in order to release the required amount
of mixture. Close the tap and relocate drip tray beneath it.
In case all of the mixture is extracted, turn machine off. In case less
than 1/4 of the mixture remains in the tub, it is recommended to re-
move all of it and put in the refrigerator, as it could cause foam or
squirts.
6.6
Partial tap washing
Immediately following an extraction of mix (however small), all trace
of the mix must be removed from the inside of the tap.
Note: partial washing is carried out with the tap off.
Place a container under the extraction tap and press the WASH button [K9]. Allow the water to run until it is clear. Then stop
the process by pressing the WASH button [K9] again.