A2Z Ozone SP - Series - Manual (Page 3)

This manual covers the SWIMMING POOL OZONE GENERATOR MODEL SP-Series Corona
Discharge (CD) Ozone Generators. A2Z Ozone Systems Inc. reserves the right to make changes to
the product covered in this manual to improve performance, reliability, or manufacturability.
Make sure that this manual is used with the original product it was shipped with. Although every
effort has been made to ensure accuracy of the information contained in this manual, A2Z
Ozone Systems assumes no responsibility for inadvertent errors.
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ AND FOLLOW ALL INSTRUCTIONS.
• Read this manual completely before attempting installation and/or operation.
• Install in accordance with the installation instructions.
• Connect to a grounded, grounding type receptacle only.
Warning - To reduce the risk of electrical shock, replace damaged electrical cable immediately.
• Follow all applicable electrical codes.
• Electric shock hazard. Be sure to turn power OFF and disconnect from power source
before any Service work is performed. Failure to do so could result in serious injury or
death. A licensed, qualified electrician should make all electrical connections.
• Install the ozone generator at least five feet from the water using nonmetallic plumbing.
• Install ozone check valves to prevent water from contacting the electrical equipment.
• The electrical supply for this product must include a suitably rated switch or circuit
breaker to open all ungrounded supply conductors to comply with Section 422-20 of the
National Electrical Code, ANSI/N FPA 70-1987. The means of disconnecting the
equipment must be readily accessible to the operator(s) but installed at least five feet
from the water.
• Ambient temperature around the equipment should be between 40 and 100 Deg. F (4.5
to 38 Deg. C). If the equipment is installed in an environment with temperatures over
100 Deg. F, additional air cooling must be provided. Installation without additional air
cooling in an environment where temperatures exceed 100 Deg. F for any continuous 24
hour period will void the warranty.
• The system should be sized appropriately for its intended use by a qualified professional
familiar with the application. The manufacturer for its intended use must validate this
equipment.
Warning - Short term inhalation of high concentrations of ozone and long term inhalation of low
concentrations of ozone can cause serious harmful physiological effects. DO NOT inhale ozone
Gas produced by this device.
• For your safety, do not store or use gasoline, chemicals or other flammable liquids or
vapors near this or any other appliance.
• A spontaneous and violent ignition may occur if oil, grease or greasy substances come in
contact with oxygen under pressure. These substances must be kept away from oxygen
regulators, cylinder valves tubing and connections, and all other oxygen equipment.
IT’S HIGHLY RECOMMENDED TO SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE!
3