Opticon PHL 7200 User Manual - Manual (Page 32)

OPTICON
User's manual
PHL-7000 series
2-13
2.4 Handling the PDT
2.4.1 Starting the PDT
Press the power key to turn ON/OFF the PDT. If the PDT does not power on, perform a cold
boot, see chapter 2.7 “Resetting”.
CAUTION: When a battery is fully inserted in PDT for the first time, the PDT powers on
and boots automatically.
Figure 2-13 Starting the PDT
2.4.2 Power on / off
To turn ON the PDT
Press the power key briefly ( ). If the PDT does not power on, perform a cold reset, see
chapter 2.7.
While the PDT initializes its file system, the splash screen displays for about 30 seconds
followed by the calibration screen. Every time you perform a cold reset, these screens will
appear.
To turn OFF the PDT
Press the power key again. This action does not actually turn off the PDT, it only turns the PDT
into suspend mode. All running applications remain as you left them, until you press the power
key again to resume operation of the PDT.
When the PDT is powered on for the first
time, it initializes its system. A splash
screen (figure 2-13) appears for a short
period of time followed by the WinCE.NET
4.2 window.