Vinten Radamec HS-105P Pan & Tilt Head - Manual (Page 21)

HS-105P pan and tilt head
20
the HS-105P studio pan/tilt head using the supplied lens cable. A variety of lens cables are
available to suit the servo lens drive supplied with your installation.
Native lens drive
The native lens drive is usually attached to an appropriate position on the HS-105P studio pan/
tilt head main cover [1]. A combined lens and power/data cable (V3990-5005) is used to
connect between the power/data socket on the head [20] and the Power/data In socket on the
native lens drive. This combined lens and power/data cable (V3990-5005) connects to the
standard floor cable (AM-SP-CAB-XXX) supplied with the HS-105P studio pan/tilt head as
shown in Fig. 9.
If the native lens drive is installed with the HS-105PE-NLD environmental head, the lens drive
must be installed within an environmental housing along with the camera and any other
accessories. Connect the supplied environmental cable (V3980-5035) between the NLD socket
on the HS-105PE-NLD head and the Power/data in socket on the native lens drive as shown in
Fig. 10.
Fig 9 HS-105P pan/tilt studio head with native lens drive - cabling
V3977-0001
HS-105P
V3990-5005
AM-PSD27-5R
AM-SP-CAB-XXX