ChemoMetec NC-100 - Manual (Page 11)

1 Installation
1
1 Installation
When the NucleoCounter is connected to a computer running NucleoView it is possible to
register the estimated cell concentration and the collected image of the NucleoCassette
chamber. Connecting a NucleoCounter to a computer does not affect the operation of the
NucleoCounter in any way and the NucleoView software performs no additional image
analysis.
The installation 1 procedures below describe the installation of the NucleoView software
and the USB driver on computers running Windows 7. It is possible to install NucleoView
and the USB driver on computers running other operating systems than Windows 7. For a
list of supported operating systems please refer to chapter 8 Technical specifications.
The communication between the NucleoCounter and NucleoView is based on the USB 1.1
protocol, thus the computer must be equipped with an USB 1.1 compatible port.
NOTICE - IMPORTANT!
Before installation of NucleoView Package ver. 2.3, check if an older version
of NucleoView is installed on the computer.
Any other version of NucleoView is most likely to be located in the folder
C:\Nucleoview.
If present it must be uninstalled by executing the uninst.exe file placed in
the folder C:\Nucleoview.
If no older version of NucleoView is installed on the computer follow the directions in
chapter 1.1 Installation of the NucleoView Package ver. 2.3 - Windows 7.
If an older version of NucleoView is installed on the computer, it has to be uninstalled
before NucleoView Package ver. 2.3 can be installed. Follow the 3 steps below.
1. Uninstall the older version of NucleoView (see chapter 1.2.1 Removal of
NucleoViewTM - Windows 7)
2. Install NucleoView Package ver. 2.3 by following the directions in chapter
1.1 Installation of the NucleoView Package ver. 2.3 - Windows 7
The NucleoCounter will then be ready for use with the NucleoView software ver. 2.2
1
.
1
This installation is called ”NucleoView Package ver. 2.3”, since it contains a new driver for
64-bit OS also. However the actual NucleoView program is still ver. 2.2.