ChemoMetec NC-100 - Manual (Page 29)

4 Measurement tab
19
4.5 Browse and Today
Each day NucleoView is launched in data collection mode, a new session (folder) is
created. The folder’s name is the date of the session (yymmdd). When NucleoView is
launched in the Viewer mode, no new folder is created. It is possible to browse sessions
created at an earlier date in both program modes.
When a measurement is performed and data is transferred to the computer, a file
containing the measurement data is created. The file is shown in the file list, and the file
name consists of the date of analysis and a running number as “yymmdd – nnn", see figure
15.
Figure 15 The file list (bottom), Path -, Comment - and Operator field.
It is possible to browse through files or results from the active session. To select and view
a file from the list use the mouse. The selected file will be displayed including all manually
entered data such as operator, comment and multiplication factor.
To browse files from other sessions, follow the directions below.
1. Click the “Browse…” button. This activates a dialogue where another session,
which is to become the active session, can be located.
2. Use the mouse to double click on the session or highlight it and click “Open”.
3. Click “Select Cur Dir” and the session will be displayed in NucleoView. The files will
appear in the file list and it is possible to browse through them using the mouse.
The selection of a session from a previous date does not affect the transmission of data
from the NucleoCounter. If the active session is not the session of the day when data is