Longshine LCS-WRN-3211 - Manual (Page 21)

Wireless 11n Router
20
a router or AP. It is also know as a peer-to-peer network.
Infrastructure Mode: the wireless network contains at least one
wireless client and one wireless AP or router. This client connects to
Internet or intranet by communicating with this wireless AP.
SSID Service set identifier (SSID) for the name of the wireless network.
Channel Width Select to use 20MHz or 40MHz as the wireless channel frequency.
Control Sideband
If you have selected the channel width of 40MHz for this router, you
can control this router to use the frequency for a deflection of
“Upper” or “Lower.”
Channel Number Select a channel for the wireless network of this device.
Country
This contains USA(FCC), Canada(IC), Europe(ETSI), Spain,
France, Japan(MKK)
Broadcast SSID
If you enable "Broadcast SSID", every wireless station located
within the coverage of this wireless router can discover this wireless
router easily. If you are building a public wireless network, enabling
this feature is recommended. Disabling "Broadcast SSID" can
provide better security.
WMM
This will enhance the data transfer performance of multimedia
contents when they’re being transferred over wireless network.
WMM is not available in 11n mode.
Data Rate
The transmit limitation of data packets of this wireless router. The
wireless router will use the highest possible selected transmission
rate to transmit the data packets.
Associated Client
Click "Show Active Clients" button, then an "Active Wireless Client
Table" pops up. You can see the status of all active wireless
stations that are connecting to the access point.
Enable MAC clone
Mark the checkbox to clone the MAC address of the device. This
function is only available when you set this router as Client mode.
You can also manually set the MAC address in WAN setting.
Enable Universal
Repeater Mode
Mark this checkbox to enable Universal Repeater Mode which acts
this device as an AP and client simultaneously.
SSID of Extended
Interface
While you enable the Universal Repeater Mode, you have to
specify an SSID for the extended interface.
* Please click on the Apply Changes button or the Reset button at the bottom to save/reset the configurations.
1. Multiple APs
This is the window that pops up after clicking the button.
Select one of the AP, and then click the button “Show”, “Active Wireless Client Table ” window
pops up.