Vortech 2003-2005 Lexus 3.0L IS300 - Manual (Page 20)

P/N: 4LA020-010
©2007 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
11JUL07 v1.1 Lexus(4LAv1.1)
12
POWER STEERING COOLER PREVIOUSLY
ATTACHED TO CORE SUPPORT
ECU ENCLOSURE 10mm HEADED
SCREW
LINE BRACKET
CUT HERE
6. CHARGE COOLER INSTALLATION, cont’d
Fig. 6-g
Fig. 6-h
Fig. 6-i
G. Remove the three retaining screws at the top
of the grill. Unclip the bottom edge of the grill.
Remove the grill and set aside.
H. Locate and remove the two 10mm headed
screws that secure the P/S cooler to the front
core support. Disconnect the rubber P/S
hoses from the steel P/S line assembly locat-
ed near the P/S reservoir. Remove the power
steering cooler and the steel P/S line assem-
bly located on the driver’s side of the radiator
and discard. (See Fig. 6-g.) To gain access
to the assembly on the driver’s side, you will
first need to temporarily remove the three
10mm headed retaining screws that secure
the ECU enclosure and pull the enclosure
upward to gain access to the 10mm headed
screw that retains the line bracket to the top
of the frame rail. Once you remove the line
bracket, re-secure the ECU enclosure using
the factory hardware. (See Fig. 6-h.)
NOTE: Leave the rubber lines connected to the
power steering pump.
I. Remove the two retainers securing the top of
the A/C condenser. Tilt the condenser back
toward the engine (be careful not to damage
the condenser
).
J. Remove the bolt securing the hood latch
assembly to the core support. Cut approxi-
mately 9" from the bottom of this mount.
(See Fig. 6-i.)