AXING SKM 1-03 - Manual (Page 14)

Operation Instructions SKM 1-03/-04/-05/-06 and 2-03/-04
Chapterl 3: Programming
14 © AXING AG | Switzerland | Reserving change in design and type - We cannot be held liable for printing errors 2014-09-17
– Save the name by pressing EXIT.
 PMT PID
 Video PID
 Audio PID
 Program Number
 Logical Channel Number
 Output Transport Stream ID
 Output Original Network ID (used only in big cable operator networks)
 Network name (only SKM 1-05)
 Service Provider (only SKM 1-05)
If two or more modules are used, enter consecutive numbers into the parameters „Program Number“ and
„Output Transport Stream ID“. E.g. “1” for module 1, “2” for module 2 etc.
3.4 Factory Defaults
Select the menu item "Set Factory Defaults" and confirm with OK.
The device is set to the factory defaults settings.
3.5 Exit the configuration
Select the menu item “Exit” and confirm with OK.
After selecting the menu item “Exit”, the programming is ended. All settings are saved.
The programming selection switch must be set to OFF position..
3.6 Other functions
Additional settings can be made without starting the main menu.
Following described settings can only be done, if all menus are closed.
Setting the audio level
The audio level on the A/V monitor output can be adjusted using the VOL
 / VOL  keys.
Setting of output channel
By pressing of the "UHF"-button a point appears in the 7 segment display.
By CH

/CH

buttons the designated output chanel can be selected.
By pressing the OK button the channel will be transmitted.
Fig. 22: Exit the configuration
Fig. 23: Setting the audio level