DynaScan 46″ Video Wall Super Narrow Bezel LCD DS46LX2 - Manual (Page 3)

DS32CR \DS42CR \DS46CR \DS46LX Series
iii
Safety Instructions
Read and follow these instructions when connecting
and using your Public Information Display:
• Unplug the display if you are not going to
use it for an extensive period of time.
• Unplug the display if you need to clean it
with a slightly damp cloth. The screen many
be wiped with a dry cloth when the power is
off. However, never use alcohol, solvents or
ammonia-based liquids.
• Consult a service technician if the display
does not operate normally when you have
followed the instructions in this manual.
• The casing cover should be opened only by
qualified service personnel.
• Keep the display out of direct sunlight and
away from stoves or any other heat source.
• Remove any object that could fall into
the vents or prevent proper cooling of the
display’s electronics.
• Do not block the ventilation holes on the
cabinet.
• Keep the display dry. To avoid electric
shock, do not expose it to rain or excessive
moisture.
• If turning off the display by detaching power
cable or DC power cord, wait for 6 seconds
before attach the power cable or DC power
cord for normal operation.
• To avoid the risk of shock or permanent
damage to the set do not expose the display
to rain or excessive moisture.
• When positioning the display, make sure the
power plug and outlet are easily accessible.
• IMPORTANT: Always activate a screen
saver program during your application. If
a still image in high contrast remains on
the screen for an extended period of time,
it may leave an ‘after-image’ or ‘ghost
image’ on the front of the screen. This is
a well-known phenomenon that is caused
by the shortcomings inherent in the LCD
technology. In most cases the afterimage
will disappear gradually over a period of
time after the power has been switched off.
Be aware that the after-image symptom
cannot be repaired and is not covered under
warranty.
Warnings and Precautions
KNOW THESE SAFETY SYMBOLS
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
This symbol indicates high voltage is present
inside. It is dangerous to make any kind of
contact with any inside part of this product.
This symbol alerts you that important literature
concerning operation and maintenance has
been included with this product.
Note to CATV system installer: This reminder is provided to
call CATV system installer’s attention to Article 820-40 of the
National Electrical Code (Section 54 of Canadian Electrical
Code, Part I), that provides guidelines for proper grounding and,
in particular, specifies that the cable ground shall be connected
to the grounding system of the building as close to the point of
cable entry as practical.
CAUTION: FCC/CSA regulations state that any unauthorized
changes or modifications to this equipment may
void the user’s authority to operate it.
CAUTION: To prevent electric shock, match the wide blade
of plug to the wide slot, and fully insert the plug.
IMPORTANT: One Federal Court has held that unauthorized
recording of copyrighted TV programs is an
infringement of U.S. copyright laws. Certain
Canadian programs may also be copyrighted and
any unauthorized recording in whole or in part
may be in violation of these rights.
TO PREVENT DAMAGE WHICH MAY RESULT IN FIRE
OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
The Socket-outlet shall be installed near the apparatus and
shall be easily accessible.