LD Systems ZONE 622 - Manual (Page 10)

connectionS, ConTRoLS, AnD InDICAToRS:
40 MIC InPUT 1 - 2
Balanced microphone inputs INPUT 1 and 2 with a
6.3 mm jack. There is no phantom power on these
microphone inputs.
41 MIC SWITCH InPUT 1 - 2
In pressed position, the microphone input of the
respective channel is active and the line input is
muted.
42 TRIM InPUT 1 - 2
Switch 41 in the released position: To harmonise
playback devices (CD player, MP3 player etc.) with
different output levels, adjust the input gain of the
channels 3 - 5 with a suitable screwdriver.
Switch 41 in the pressed position: Pre-amplification
for the microphone input. Use a suitable screwdriver
to adjust.
43 MIC 1 - 2
Balanced microphone inputs 1 and 2 with a 6.3
mm jack. Both microphone inputs are equipped
with a 12 V phantom power.
44 USB
The USB-interface (USB 1.1) allows for the mixer
to be used as an audio interface. In other words,
audio recording and playback can be done
through a connected computer with Windows
Operating System (Windows XP, Vista, 7, 8) and
Apple Macintosh OS 10.5 or higher. Separate
drivers are not necessary for the installation.
Once connected to a suitable USB port on your
computer (USB 1.1, USB 2.0), the drivers are auto-
matically installed. The audio interface is detected
as "USB Audio CODEC" interface on both Windows
and Apple Macintosh computers.
The recording signal consists of the sum signal
which is sourced after the master level control and
the max level control, and is therefore dependent
on it. Audio playback is via the line channel INPUT
5. This requires the switch 45 on the back panel to
be pressed (USB).
45 USB / LIne
Switch for selecting the signal source for the line
channel INPUT 5. In pressed position, the USB-
interface (44) is selected, if not pressed, the line
input (37) is selected as the signal source.
10
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ES
pA
ño
L
po
LSKI
IT
ALIAN
o