Omnia Audio Omnia.ONE User Manual
Page 6
iv
9. If you are using the Omnia’s built-in stereo generator, navigate to the Input/Output / Stereo Generator menu and adjust
the appropriate composite output level control (Comp #1 or Comp #2) for 100% modulation on your station’s
modulation monitor. Similarly, adjust the Pilot Lvl control so that the 19kHz stereo pilot injection level indicates
between 8 and 10 percent as shown on your station’s stereo modulation monitor. If your modulation monitor does not
show pilot injection but you are certain that the total modulation is correct at 100%, simply set the Pilot Lvl control to
9.0%.
If you are using the AES/EBU output to feed pre-emphasized audio to your linear STL or digital exciter, navigate
instead to the Input/Output / Output menu and adjust the appropriate output level control for the equipment that
follows the Omnia.ONE. Ensure that any limiters, clippers and/or pre-emphasis in the exciter/transmitter are defeated.
10. Navigate back to the Main Menu, highlight Preset: and click. Rotate the jog wheel to display the preset you would
like to start with and click to select it. Go through all of the presets and start with one that sounds best to you.
11. We suggest that each time you try a new factory preset, you adjust the Clip Drive in the Processing / Adjust
Processing / Clipper menu as follows: Starting with the default setting for a preset, adjust it down in 0.5 dB steps until
the loudness just drops below the desired level and then bring it up slightly from there. This should be the optimum
setting for your station and market. With most presets, there should be room to turn it up a bit as well if a bit more
loudness is needed. Turn it up just enough to achieve the desired loudness level. If you have to turn it up too much, to
the point where distortion becomes obtrusive, it would probably be best to start with a more aggressive preset.
The Omnia.ONE Quick-Start Setup is now complete. For more detailed installation and operating instructions (including
details about every control function) and to learn about some of the features that make the Omnia.ONE unique, please refer
to the latest version of the full Omnia.ONE user manual available on the Omnia website here: