Samson Concert 88x Wireless Lavalier Microphone System with LM10 Miniature Lav (D: 542 to 566 MHz) - Manual (Page 13)

Concert 88x Wireless System 13
ENGLISH
FR
AN
ÇA
IS
DE
U
TSC
H
E
ES
PA
Ñ
OL
IT
ALI
AN
O
Quick Start - Single System Setup
3. Plug in receiver 4. Turn on receiver 5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control 7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set 7. Install batteries 8. Turn on belt pack transmitter
3. Plug in receiver 4. Turn on receiver 5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control 7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set 7. Install batteries 8. Turn on belt pack transmitter
Turn on the power to the transmitter by pressing
and holding Power switch. The indicator LED will
light green.
Position the transmitter about 6"–12" (15cm–30cm) from the front of the CR88x with the
transmitter's IR window facing the IR transmitter on the front panel of the CR88x receiver.
3. Plug in receiver 4. Turn on receiver 5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control 7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set 7. Install batteries 8. Turn on belt pack transmitter
Press the SCAN button for more than 2 seconds
(the display will start to flash quickly) on the front of
the CR88x receiver to scan for an available channel.
Once the optimal channel is selected the receiver
will enter IR Set mode. The display will flash slowly
in IR Set mode.
If you want to set a transmitter to the receiver’s
currently selected channel, press and hold the SCAN
button for more than 10 seconds (until the display
flashes slowly) to enter IR Set mode directly.
3. Plug in receiver 4. Turn on receiver 5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control 7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set 7. Install batteries 8. Turn on belt pack transmitter