Samson Concert 88x Wireless Lavalier Microphone System with LM10 Miniature Lav (D: 542 to 566 MHz) - Manual (Page 14)

14
Quick Start - Single System Setup
When the transmission is complete, the CR88x will receive RF signal and the tone key from the
transmitter. The READY indicator will light on the front panel of the CR88x receiver.
Turn on your connected amplifier or mixer, but keep the
volume all the way down. Set the Volume knob on the
CR88x fully clockwise (to its “10” setting). This is unity
gain.
Speak or sing into the microphone, or if you are using
the transmitter with a connected instrument, play the
instrument at normal performance level. Slowly raise the
volume of your amplifier or mixer until the desired level is
reached.
If you find the system has noticeable dropouts, reduced overall working range, or unexpected
noise bursts, change the operating channel of the system using the steps above.
3. Plug in receiver 4. Turn on receiver 5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control 7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set 7. Install batteries 8. Turn on belt pack transmitter
Multiple System Setup
When using multiple systems, each system must be set to a different operating channel.
Transmitter and receiver pairs must be on the same channel plan in order to work together.
When setting an additional transmitter, make sure to close all other transmitter battery
compartments to ensure that the IR Lens is covered.