Gigbar rf remote control, Gigbar rf remote operation, Operation gigbar rf remote control – CHAUVET DJ GigBAR Move + ILS 5-in-1 Lighting System with Moving Heads, Pars, Derbys, Strobe, and Laser Effects User Manual
Page 31
Page 25
GigBAR MOVE + ILS User Manual Rev. 3
Operation
GigBAR RF Remote Control
The GigBAR MOVE + ILS can be operated with the GigBAR RF Remote. To enable RF wireless control,
follow the instructions below.
GigBAR RF Remote Operation
1. Press
<MENU>
to view the main menu on the display.
2. Use
<UP>
or
<DOWN>
until
SETUP
is selected.
3. Press
<ENTER>
.
4. Use
<UP>
or
<DOWN>
until
RF
is selected.
5. Press
<ENTER>
.
6. Use
<UP>
or
<DOWN>
to select
COMMON
(to connect a
GigBAR MOVE + ILS to any RF remote) or
BIND
(to pair an RF remote
to a specific GigBAR MOVE + ILS fixture).
7. Press
<ENTER>
.
Black Out
To black out the lasers with the RF remote:
•
Press
<BLACK OUT>
on the RF remote.
This will turn off all the lasers until the button is pressed again.
NOTE: The RF remote will not respond to any inputs when Black Out is
activated. If the product does not respond when a button is pressed, try
pressing
<BLACK OUT>
. Black Out may have been activated.
Strobe
To activate strobe in manual mode using the RF remote:
1. Press
<STROBE>
on the RF remote.
2. Press
<+>
or
<–>
to adjust the strobe.
Dimmer
To adjust the dimmer using the RF remote:
1. Press
<DIMMER>
on the RF remote.
2. Press
<+>
or
<–>
to adjust the brightness.
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode with the RF remote:
1. Press
<AUTO>
on the RF remote.
2. Press
<+>
or
<–>
to choose between the different auto programs.
Speed
To adjust the auto program/spot speed with the RF remote:
1. Press
<SPD>
on the RF remote.
2. Press
<+>
or
<–>
to increase or decrease the program speed.
Sound-Active Mode
To turn on Sound-Active mode with the RF remote:
1.
Press and hold
<SOUND>
on the RF remote.
2.
Press
<+>
or
<–>
to select a sound-active program.
To adjust the sound sensitivity:
1.
Press
<SENS>
on the RF remote.
2.
Press
<+>
or
<–>
to increase or decrease the sensitivity.
Freeze
To pause an auto program using the RF remote:
1. Press
<FREEZE>
on the RF remote.