FUJITSU PRIMERGY BX600 S3 User Manual
Page 65
BX600 S3
Operating Manual
65
Preparation for Use and Operation
Updating BX600 System Components
⎜
Console Redirection Switch Blade
page_3_2.
⎟
⎜ -------------------------------------------------------------------------------- ⎟
⎜ (1) Console Redirect Switch Blade_1
⎟
⎜ (2) Console Redirect Switch Blade_2
⎟
⎜ Enter selection or type (0) to quit: 1
⎟
Ê
Enter the desired switch blade.
The command line interface session starts.
⎜ Press <Ctrl-Q> Return Console Menu
⎟
⎜
⎟
⎜
⎟
⎜
⎟
⎜
⎟
⎜
⎟
Ê
Press the
Return
key to switch to command mode.
Command mode is indicated by the prompt
Console#
.
⎜
CLI session with the Switch Blade is opened.
⎟
⎜
To end the CLI session, enter [Exit].
⎟
⎜
⎟
⎜ Condole>enable
⎟
⎜ Console#config
⎟
⎜ Console(config)#interface vlan 1
⎟
⎜ Console(config-if)#ip address 10.50.50.51 255.0.0.0
⎟
⎜ Console(config-if)#exit
⎟
⎜ Console#show ip interface
⎟
⎜ TP address and netmask: 10.50.50.51 255.0.0.0 on VLAN 1,
⎟
⎜ and address mode: User specified
⎟
⎜
⎟
⎜ Console#
⎟
Ê
Enter the commands specified above.
I
The specifications for the IP address and the subnet mask are merely
examples and are probably not valid for your system.
Ê
Terminate the command line session by pressing
{Strg}
[Q]
.
Ê
Check the newly created LAN connection by pinging the switch blade on the
client system.
Ê
Install your TFTP server software and start it.
Ê
Download the firmware file for the TFTP update from the Fujitsu Technology
Solutions download server at