FUJITSU PRIMERGY BX600 S3 - Manual (Page 67)

BX600 S3 Operating Manual 67
Preparation for Use and Operation Updating BX600 System Components
Figure 25: Transferring the new operation code image file
Ê Click Transfer from Server .
Ê Wait a few minutes until the update process is complete. Refresh the
browser for viewing.
Ê Select the new image file in the pop-up window (red arrow) and click Apply
Changes .
Figure 26: Selecting Start-Up Operation Code Image File
Ê Select Reset in the navigation bar.
I
After resetting, the switch blade will reboot. However, all settings
specified previously (IP address etc.) will be lost and must be
reentered on the management console.
Ê Repeat the firmware update procedure for each installed switch blade.