Gateway 955 - Manual (Page 84)

78
Chapter 4: Installing Components
www.gateway.com
6
Locate the old battery on the system board and note its orientation. You
will need to install the new battery the same way.
7
Push the battery retention clip away from the battery until the battery lifts
up, then remove the old battery. You can use a screwdriver to help lift the
battery.
8
Make sure that the positive (+) side of the new battery is facing up, then
press the new battery into the socket until it snaps into place.
9
Follow the instructions in “Closing the server case” on page 48 .
10
Turn on your server, then press F2 when the Gateway logo screen appears
during startup.
11
Restore any BIOS settings that you wrote down in Step 3 .
12
Save all your settings and close the BIOS Setup utility.
CMOS
battery