Ap51xx>admin(network.wan)> set – Motorola AP-51XX User Manual
Page 376
AP-51xx Access Point Product Reference Guide
8-42
AP51xx>admin(network.wan)> set
Description:
Defines the configuration of the access point WAN port.
Syntax:
Example:
admin(network.wan)>
admin(network.wan)>
set dhcp disable
admin(network.wan)>
set ipadr 157.169.22.5
admin(network.wan)>
set dgw 157.169.22.1
admin(network.wan)>
set dns 1 157.169.22.2
admin(network.wan)>
set auto-negotiation disable
admin(network.wan)>
set speed 10M
admin(network.wan)>
set duplex half
admin(network.wan)>
set mask 255.255.255.000
admin(network.wan)>
set pppoe mode enable
admin(network.wan)>
set pppoe type chap
admin(network.wan)>
set pppoe user jk
admin(network.wan)>
set pppoe passwd @#$goodpassword%$#
admin(network.wan)>
set pppoe ka enable
admin(network.wan)>
set pppoe idle 600
For an overview of the WAN configuration options available using the applet (GUI), see
Configuring WAN Settings on page 5-16
set wan
enable
/
disable
Enables or disables the access point WAN port.
dhcp
enable
/
disable
Enables or disables WAN DHCP Client mode.
ipadr
<idx>
<a.b.c.d>
Sets up to 8 (using <indx> from
1
to
8
) IP addresses <a.b.c.d> for the
access point WAN interface.
mask
<a.b.c.d>
Sets the subnet mask for the access point WAN interface.
dgw
<a.b.c.d>
Sets the default gateway IP address to <a.b.c.d>.
dns
<idx>
<a.b.c.d>
Sets the IP address of one or two DNS servers, where <indx>
indicates either the primary (
1
) or secondary (
2
) server, and <a.b.c.d>
is the IP address of the server.
auto-
negotiation
enable
/
disable
Enables or disables auto-negotiation for the access point WAN port.
speed
<mbps>
Defines the access point WAN port speed as either 10 Mbps or 100
Mbps.
duplex
<mode>
Defines the access port WAN port duplex as either half or full.
pppoe
mode
enable
/
disable
Enables or disables PPPoE.
user
<name>
Sets PPPoE user name.
passwd
<password>
Defines the PPPoE password.
ka
enable
/
disable
Enables or disables PPPoE keepalive.
idle
<time>
Sets PPPoE idle time.
type
<auth-type>
Sets PPPoE authentication type.