Ap51xx>admin(network.wan.nat)> set – Motorola AP-51XX User Manual
Page 379
8-45
AP51xx>admin(network.wan.nat)> set
Description:
Sets NAT inbound and outbound parameters.
Syntax:
Example:
admin(network.wan.nat)>
set type 2 1-to-many
admin(network.wan.nat)>
set ip 2 10.1.1.1
(this command is used when NAT is 1-to-1)
admin(network.wan.nat)>
show 2
WAN IP Mode
: enable
WAN IP Address
: 157.235.91.2
NAT Type
: 1-to-many
Inbound Mappings
: Port Forwarding
unspecified port forwarding mode
: enable
unspecified port fwd. ip address
: 111.223.222.1
one to many nat mapping
-------------------------------------------------------------------------------
LAN No.
WAN IP
-------------------------------------------------------------------------------
1
157.235.91.2
2
10.1.1.1
For an overview of the NAT options available using the applet (GUI), see
Configuring Network Address Translation (NAT) Settings on
set type
<index>
<type>
Sets the type of NAT translation for WAN address index <idx> (
1
-
8
) to
<type> (none, 1-to-1, or 1-to-many).
ip
<index>
<ip>
Sets NAT IP mapping associated with WAN address <idx> to the
specified IP address <ip>.
inb
<index>
<ip>
<mode>
Sets inbound IP address for specified index <index> <ip address>
Sets inbound mode for specified index <index> <enable/disable>
outb
<index>
<ip>
<from> <to>
Sets outbound IP address for specified index <index> <ip address>
Sets outbound NAT destination <LAN1 or LAN2> <WAN ip 1-8 or None>.